Dacia Solenza (engine E7J). Instruction - page 16

ENGINE

E7J-262

10

ENGINE ASSEMBLY

10 - 39

DISMOUNTING

Place the vehicle on a two-column eleva-

tor.

Disconnect the battery.
Drain the oil from engine.
Dismount the engine shield.
Dismount :

- front right wheel;
- front right wheel side fairing;
- right side tie-rod (1);

TIGHTENING MOMENTS (daNm)

Lower casing screws

1

Wheels screws

7,5

Tie-rod attachment nut

7,5

Tie rod attachment screw

2,7

Anti-roll connecting rod attachment screw (on frame)

6,2

Anti-roll connecting rod attachment screw (on gearbox) 10,5

- thermal protection screen;
- descending tube (see chapter 19 “Ex-

haust”).

- Anti-roll connecting rod (2);

Lower casing

2

1

Dismount the lower casing attachment screws.
In order to dismount the screws from crank-

shaft pulley side, a cardanic joint is to be used.

ENGINE E7J-262

10

ENGINE ASSEMBLY

10 - 40

Lower casing

REMOUNTING

Clean the lower casing and the cylinders casing of old sealant material.
Apply a layer (D) of RHODORSEAL 5661 of about 3 mm thick, according to the bellow

drawing.

Do not forget the replacement of the two half-moon gaskets from casing ends (A).
Perform the dismounting operations in the reverse order.
Tighten the screws and nuts to the required moment.

REMARK:
Relative displacement between lower casing and cylinders casing, on the assem-

bling surface with the gearbox, must not exceed 0.3 mm.

ENGINE

E7J-262

10

ENGINE ASSEMBLY

10 - 41

DISMOUNTING

Drain the oil from the engine.
Dismount:

- lower casing (see chapter 10”Lower casing on vehicle”).

Dismount the oil pump attachment screws on casing.
Dismount the drive chain from the oil pump gear.
Dismount the oil pump cap.
Check the gears clearance in the oil pump (see chapter 10” Engine assembly”)

REMOUNTING

Perform the dismounting operations in the reverse order;
Fill up engine with oil
Check the oil pressure at 80 °C:

At idling 1 bar;
At 4000 rot/min 3 bar.

Oil pump attachment screws

2.5

Oil pump cap attachment screws

1

TIGHTENING

MOMENTS

(daNm)

Oil pump

ENGINE E7J-262

10

ENGINE ASSEMBLY

10 - 42

Multi-purpose support

TIGHTENING MOMENTS (daNm)

Support attachment screws

4

Support upper attachment screws

2

DISMOUNTING

Place the vehicle on a two-column elevator.
Disconnect the battery.
Dismount:

- compressor (see chapter 62”Air

conditioning”) for vehicles equipped with air
conditioning unit;

- power steering pump (see chapter 36 “

Power steering pump”) for vehicles equipped
with power steering.

- Dismount the support attachment screws.

2

2

REMOUNTING

Position the support and pre-tighten the

central screw (1) to the required moment of
0.25 daNm.

Mount the others attachment screws.
Tighten to the required moment observing

the sequence shown in the drawing.

Remount the other elements by

performing the dismounting operations in the
reverse order.

Supp

Support AD

Support AC/AD

Рассказать друзьям