Dacia Solenza (engine E7J). Instruction - page 8
ENGINE
E7J-262
10
ENGINE ASSEMBLY
10 - 7
Power train group
Dismount the hydro-elastic buffer nut (on
the right side).
Remove the power train and place it on a
support.
Disconnect the pressure controller
connector for power steering.
Dismount:
- hoses from oil reservoir for power
steering by means of pliers MOT 1202-01;
- high pressure pipe from the power
steering pump.
Dismount the refrigerant fluid pipes from
compressor (vehicles with AC unit).
Sustain the power train by means of the
two lifting supports using a mobile lifting device
(mobile crane).
Dismount the four attachment screws of the
power train support-battery and the elastic buffer
nut (9).
9
ENGINE E7J-262
10
ENGINE ASSEMBLY
10 - 8
Power train group
REMOUNTING
Perform the dismounting operations in the reverse order.
Tighten the screws and nuts to the required moment.
Perform:
- filling and purging of the cooling circuit (see chapter 19”Filling and purging”);
- filling with oil of the engine and gearbox;
- filling of the power steering circuit (see chapter 05 “ Draining-Filling)- for vehicles
equipped with power steering;
- filling of the air conditioning circuit with refrigerant fluid HFC 134a (see chapter 62 “Air
conditioning”).
Adjust the clutch pedal stroke (see chapter 37”Clutch control adjustment”).
REMARK:
At each operation implying battery dismounting, when reconnecting the battery,
introduce the radio code, which is written on the vehicle-purchasing invoice.
ENGINE
E7J-262
10
ENGINE ASSEMBLY
10 - 9
DISMOUNTING
Dismount the RPM sensor 2 attachment screws on clutch casing.
Detach the starter electric connections.
Dismount the starter.
Disconnect the electric connector 1 of the reverse driving contact.
Dismount the engine wiring attachment on gearbox.
Dismount the screws and nuts for assembling engine-gearbox.
Separation - Gearbox
REMOUNTING
Perform the dismounting operations in the reverse order.
Tighten the nuts and screws to the required moment.
TIGHTENING MOMENTS (daNm)
RPM sensor
0.8
Starter attachment screws
4.4
Gearbox attachment on engine:
nuts M 10
4.4
screws M10 - 90
4.4
screws M10 - 35
2.1
1
ENGINE E7J-262
10
ENGINE ASSEMBLY
10 - 10
ENGINE UNFITTING
Dismount:
- alternator and its belt;
- oil dipper guide;
- induction coil, after its electric connector
and spark plugs cables have been disconnected.
ENGINE FITTING
Perform the dismounting operations in the
reverse order.
Tighten the screws and nuts to the required
moment.
Separation – Unfitting
Disconnect the electric connectors and
dismount the engine wiring.
Dismount then:
- valve body;
- injection ramp;
- clutch disc and mechanism;
- engine flywheel;
- intake manifold;
- thermal screen and exhaust manifold;
- water inlet pipe;
- thermostat support.
For the vehicles equipped with air
conditioning unit and/or power steering
dismount additionally:
- driving belt tensioner;
- compressor belt;
- compressor electric connector;
- compressor;
- compressor support and intermediary
support.