Nissan Primera P12. Instruction - page 1
- < Предыдущая
- Следующая >
ACC-1
ACCELERATOR CONTROL SYSTEM
B ENGINE
CONTENTS
C
D
E
F
G
H
I
J
K
L
M
SECTION
A
ACC
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM ...................... 2
Removal and Installation .......................................... 2
INSPECTION AFTER INSTALLATION .................. 2
Removal and Installation .......................................... 3
SERVICE DATA AND SPECIFICATIONS (SDS) ........ 4
Tightening Torque ..................................................... 4
ACC-2
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM
PFP:18005
Removal and Installation
EBS00SJ5
YD ENGINE MODELS
REMOVAL
1.
Remove harness connector.
2.
Loosen nuts, and remove accelerator pedal assembly.
CAUTION:
●
Do not disassemble the accelerator pedal assembly. Do not remove the sensors and the switches
from the assembly.
●
Avoid impact from dropping etc. during handling.
●
Be careful to keep the assembly away from water.
●
When the harness connector of the accelerator sensor is disconnected, perform “Accelerator
Pedal Released Position Learning”. Refer to “Basic Service Procedure” in EC section.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER INSTALLATION
●
Check that the accelerator pedal moves smoothly within the whole operation range.
●
Check that the accelerator pedal securely returns to the original position.
●
For the electrical inspection of the accelerator work unit, refer to
EC-164, "DTC P0222, P0223 APP SEN-
SOR"
. (YD engine models)
●
Check that the drum of the accelerator work unit can be fully opened.
MBIA0072E
1.
Accelerator pedal assembly (work
unit)
ACCELERATOR CONTROL SYSTEM
ACC-3
C
D
E
F
G
H
I
J
K
L
M
A
ACC
Removal and Installation
EBS00SJ6
F9Q ENGINE MODELS
REMOVAL
1.
Disconnect harness connector.
2.
Loosen nuts, and remove accelerator pedal assembly.
3.
If necessary, remove accelerator pedal bracket.
CAUTION:
●
Do not disassemble the accelerator pedal assembly. Do not remove the sensors and the switches
from the assembly.
●
Avoid impact from dropping etc. during handling.
●
Be careful to keep the assembly away from water.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER INSTALLATION
●
Make sure the accelerator pedal moves smoothly within the whole operation range.
●
Make sure the accelerator pedal securely returns to the original position.
MBIB0518E
1.
Accelerator pedal bracket
2.
Accelerator pedal assembly (work
unit)
ACC-4
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Tightening Torque
EBS00SJ7
Unit: N·m (Kg-m, in-lb)
Accelerator pedal assembly (work unit) (YD engine models)
4.3 - 5.9 (0.44 - 0.60, 38 - 52)
- < Предыдущая
- Следующая >
