Engine Iveco C10/C13/C78/Cursor 13/Cursor 78. Instruction - page 13

Mount the following, tightening the screws to the prescribed
torque:

-

supports (1 and 5)

-

;alternator (2);

-

support (4) and compressor (3)
(not engine F2BE0687A*B101).

DIAGRAM FOR FITTING BELT DRIVING
FAN - WATER PUMP - ALTERNATOR

Using a suitable tool (6), work in the direction of the arrow
on the tightener (5) and mount the belt (4).

Using a suitable tool (3), work in the direction of the arrow
on the tightener (2) and mount the belt (1).

Figure 84

Figure 85

Figure 86

The tighteners are automatic, so there are no
other adjustments after assembly.

99255

99275

ENGINES

F2BE0684A*B001
F2BE0684A*B002

1. Alternator - 2. Water pump - 3. Crankshaft -

4. Compressor.

99276

Figure 87

ENGINE

F2BE0687A*B101

1. Alternator - 2. Water pump - 3. Crankshaft.

99277

NOTE

SECTION 3 - INDUSTRIAL APPLICATION

27

Figure 88

Figure 89

Figure 90

-

Connect the engine electric cable to the sensors and
control unit.
Refill the engine with lubricating oil of the prescribed
grade and quantity.

99254

Fit the arm 99360585 onto the engine lifting hooks and hook
the arm onto the hoist.
Take out the screws fixing the brackets 99361035 to the
rotary

stand.

Lift

the

engine

and

remove

the

above-mentioned brackets from it.
Complete engine assembly with the following parts,
tightening the fixing screws or nuts to the prescribed torque:

-

mount the drive (1);

-

mount the engine supports;

99253

-

mount the oil pressure adjuster valve (1).

99252

28

SECTION 3 - INDUSTRIAL APPLICATION

A. Resistance for engine warming - B. Fuel filter clogged signalling switch - C. Fuel temperature sensor - D. Engine rpm sensor

on camshaft - E. Starter motor - F. Engine intake air temperature sensor - G. Alternator - H. Boosting pressure sensor -

I. Conditioner compressor - L. EDC (MS6.2) control unit - M. Connector on engine head for connection with injector solenoid

valves - N. Water temperature for EDC (MS6.2) - O. Water temperature sensor - P. Oil pressure transmitter -

Q. Engine speed on flywheel sensor - R. Low oil pressure transmitter.

ENGINE RIGHT-HAND SIDE VIEW

ENGINE LEFT-HAND SIDE VIEW

Figure 91

Figure 92

99286

99287

Components on the engine F2B

SECTION 3 - INDUSTRIAL APPLICATION

31

Figure 93

99288

KEYS

1. Accelerator pedal position sensor / switch accelerator depressed — 2. Engine coolant temperature sensor — 3. Oversupply

air temperature sensor — 4. Fuel temperature sensor — 5. Oversupply air pressure sensor — 6. Input for electronic tachograph

(if available) — 7. Output for electronic revs counter (if available) — 8. E.D.C. system failure warning light — 9. Blink—code button

(if available) — 10. Diagnosis connector — 11. CAL L-H line — 12. Pump-injectors — 13. Warning light for pre/post-heating

activated — 14. Remote control switch for pre/post-heating activation — 15. Pre/post-heating resistance — 16. Main remote

control switch — 17. Flywheel sensor — 18. Distribution sensor — 19. Cruise Control buttons (if available) — 20. Clutch switch —

21. Primary / secondary brake switch.

BLOCK DIAGRAM

32

SECTION 3 - INDUSTRIAL APPLICATION

Рассказать друзьям