Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Instruction - page 93
4A2–30
DIFFERNTIAL (REAR)
9. While holding gears in place, insert LSD service
adapter J–39834 with long drive handle J–8592 in
differential shaft hole of case. Pull on long drive
handle J–8592 and rotate case, allowing gears to
turn. Make sure that holes in pinion mate gears align
with holes in case.
901RW070
D
It may be necessary to adjust tension on forcing
screw to rotate case.
10. Tighten forcing screw to compress the clutch packs,
to allow installation of spherical thrust washers.
11. Lubricate spherical thrust washers (2), and assemble
into case (1). Use a small screw driver to push
washers into place. Remove tools.
425RW012
12. Position differential shaft in case and drive in with
hammer. Be sure lock pin hole of differential shaft (5)
is properly aligned to allow installation of lock pin (3).
Be sure that thrust washers and differential pinion
mate gears are aligned with the differential case (4).
Install new lock pin to proper depth using a punch.
Stake metal of case over pin in two places, 180
degrees apart.
425RW013
DIFFERENTIAL (REAR)
4A2–31
Main Data And Specifications
General Specifications
Rear axle
Type
Salisbury, Semi–floating
Rear axle Size
226 mm (8.9 in)
Gear type
Hypoid
Gear ratio
4.300
Differential type
Two pinion
Lubricant Grade
GL–5: (Standard differential)
GL–5, LSD: (Limited slip differential)
Locking Differential Lubricant
80W90 GL–5
(USE Limited Slip Differential Gear Lubricant or Friction
Modifier Organic Additive)
Capacity
1.77 liter (1.87 US qt)
Torque Specifications
E04RX002
4A2–32
DIFFERNTIAL (REAR)
Special Tools
ILLUSTRATION
TOOL NO.
TOOL NAME
J–8614–01
Pinion flange holder
J–37263
Installer; Pinion oil seal
J–42379
Remover; Bearing
J–39830
Adapter; Side bearing
plug
J–8611–01
Installer; Outer bearing
outer race
J–8592
Grip
ILLUSTRATION
TOOL NO.
TOOL NAME
J–42836
Installer; Inner bearing
outer race
J–42824
Pilot;Outer
J–21777–43
Nut & Stud
J–42827
Pilot;Inner
J–39837–2
Gauge plate
J–8001
Dial indicator
DIFFERENTIAL (REAR)
4A2–33
ILLUSTRATION
TOOL NO.
TOOL NAME
J–39837–1
Disc (2 required)
J–23597–1
Arbor
J–42828
Installer; Pinion bearing
J–21784
Installer; Side bearing
J–39602
Remover; Outer bearing
J–24385–B
Spreader
ILLUSTRATION
TOOL NO.
TOOL NAME
J–39858
Clutch pack unloading
tool kit Includes
J–34174–1/J–34174–2
Screw cap and Cap
J–22342–15
Forcing screw
J–39834
Limited–slip differential
(LSD) service adapter
J–39824
Holder
J–39836
Side bearing preload
master bearings