Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Instruction - page 60
REAR SUSPENSION
3D–11
D
Install the rubber bushing by using to installer
J–43008.
NOTE: When mounting rubber bushings, be sure not to
use grease on bushings or any other nearby part.
460RY00007
Installation
1. Install upper link. Make sure that the upper link is in its
correct position.
NOTE: When mounting upper link, be sure not to use
grease bushings or any other nearby part.
460RW012
2. Install bolt, nut, rubber plate and protector. Tighten
the bolts and nuts lightly, then retighten them to the
specified torque after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install speed sensor cable.
4. Install fuel tank.
3D–12
REAR SUSPENSION
Lateral Rod
Lateral Rod and Associated Parts
460RW007
Legend
(1) Bolt and Nut (Frame side)
(2) Lateral Rod
(3) Nut and Washer (Axle side)
Removal
1. Remove nut and washer.
2. Remove bolt and nut.
3. Remove lateral rod.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Lateral rod
2. Rubber bushing (Frame side)
D
Remove the rubber bushing (Frame side) by using
remover J–39215.
901RW060
REAR SUSPENSION
3D–13
D
Install the rubber bushing (Frame side) by using
Installer J–39215.
NOTE: When mounting rubber bushings, do not use
grease on bushings or any other nearby parts.
901RW061
3. Rubber bushing (Axle side)
D
Remove the rubber bushing (Axle side) by using
remover J–39792.
901RW062
D
Install the rubber bushing (Axle side) by using
installer J–39792.
901RW063
Installation
1. Install lateral rod and make sure that the lateral rod is
in its correct position.
NOTE: When mounting lateral rod, be sure not to use
grease on bushings or any other nearby part.
460RW008
Legend
(1) Frame Side
(2) Axle Side
2. Install bolt and nut (Frame side). Tighten the bolt and
nut lightly, then retighten them to the specified torque
after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install nut and washer (Axle side). Tighten the nut
lightly, then retighten the nut to the specified torque
after the vehicle is at curb height.
Torque: 78 N·m (58 lb ft)
3D–14
REAR SUSPENSION
Stabilizer Bar
Stabilizer Bar and Associated Parts
460RW009
Legend
(1) Bracket and Bolt
(2) Link
(3) Bolt and Nut
(4) Stabilizer Bar
(5) Rubber Bushing
Removal
1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to
Wheel in
this section.
3. Remove bolt and nut.
4. Remove link.
5. Remove bracket.
6. Remove rubber bushing.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts:
D
Stabilizer bar
D
Rubber bushing
D
Link