Infiniti FX35 / FX45. Instruction - page 88
AT-280
< SERVICE INFORMATION >
DISASSEMBLY
58. Remove needle bearing from drum support edge surface.
59. Remove reverse brake piston from transmission case with com-
pressed air. Refer to
AT-261, "Oil Channel"
.
CAUTION:
Care should be taken not to abruptly blow air. It makes pis-
tons incline, as the result, it becomes hard to disassemble
the pistons.
60. Remove D-rings from reverse brake piston.
61. Use a pin punch [4 mm (0.16 in) dia. commercial service tool] to
knock out retaining pin.
SCIA2796E
SCIA5047E
SCIA5340E
SCIA2328E
DISASSEMBLY
AT-281
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
62. Remove manual shaft retaining pin with pair of nippers.
63. Remove manual plate (with parking rod) from manual shaft.
64. Remove parking rod from manual plate.
65. Remove manual shaft from transmission case.
66. Remove manual shaft oil seals using a flat-bladed screwdriver.
CAUTION:
Be careful not to scratch transmission case.
SCIA2329E
SCIA5715E
SCIA5220E
SCIA5716E
SCIA2331E
AT-282
< SERVICE INFORMATION >
DISASSEMBLY
67. Remove detent spring and spacer from transmission case.
68. Using pair of snap ring pliers, remove snap ring from transmis-
sion case.
69. Remove servo assembly (with return spring) from transmission
case.
70. Remove return spring from servo assembly.
71. Remove O-rings from servo assembly.
SCIA5248E
SCIA2333E
SCIA5679E
SCIA5717E
SCIA5719E
DISASSEMBLY
AT-283
< SERVICE INFORMATION >
D
E
F
G
H
I
J
K
L
M
A
B
AT
N
O
P
72. Remove needle bearing from rear extension (2WD models) or
adapter case (AWD models).
73. Remove parking actuator support from rear extension (2WD
models) or adapter case (AWD models).
74. Remove parking pawl (with return spring) and pawl shaft from
rear extension (2WD models) or adapter case (AWD models).
75. Remove return spring from parking pawl.
• VQ35DE models
SCIA5221E
SCIA3423E
SCIA3424E
SCIA2445E