Geely FC. Manual part - 97
Geely FC. Manual part - 97
Exterior/inner trim board--Exterior seal tape of left rear door glass
Exterior seal tape of left rear door glass
Change
Hint:
z
When assembling, please work by the sequence which is opposite with disassembling
sequence; if necessary, it will have assembling instruction.
z
Changing procedure for right side is same as left side.
Protective
adhesive tape
385
1. Disassemble exterior seal tape of left rear door glass
[68000196]
(a) Affix protective adhesive tape to the lower part of exterior
seal tape of left rear door glass.
(b) Use disassembling tool or scraper for trim tape to disas-
semble exterior seal tape of left rear door glass.
Hint: before using scraper, the needled top of scraper
should be twisted with adhesive tape.
Exterior/inner trim board--Light fender
Light fender
Change
1. Disassemble locker core and pedestal of trunk.
2. Disassemble number plate light defender [68000107]
Disassemble four screw caps, then disassemble the defender.
3. Assemble rear logo assembly [61000019]
(a) Use white gasoline to clean the assembling surface of logo.
(b) Use heating light to heat defender and logo.
(c) Assemble the logo.
Note:do not heat logo excessively
2 Fixing clamp
386
Exterior/inner trim board--Top left trim tape
Top left trim tape
Change
Hint:
z
When assembling, please work by the sequence which is opposite with disassembling
sequence; if necessary, it will have assembling instruction.
z
Changing procedure for right side is same as left side.
1. Disassemble top left trim tape [68000128]
(a) Use protective adhesive tape to affix around the trimtape.
(b) Use disassembling tool for trim tape to release the front and
rear fixing clamp of trim tape, then disassemble top left trim
tape.
Note:
z
Do not disassemble fixing clamp.
z
If fixing clamp is damaged when disassembling,
change it with new one.
2. Assemble top left trim tape [68000128]
Note: when only changing fixing clamp.
(a) Disassemble adhesive tape remaining on the surface of
body affixed trim tape, then use white gasoline to clean the
surface.
(b) Use heating light to heat the assembling surface of fixing
clamp and automobile body.
Automobile body: 40-60°C.
Trimtape: 20-30°C.
Note: do not heat the trim tape and body too much.
(c) Put the fixing clamp on the position shown in figure, then
press it into position with hand.
(d) After pressing the fixing clamp into position for over 30
minutes, then assemble top left trimtape.
Hint:
z
Surface induration time: 30 minutes.
z
Complete induration time: 24 hours.
387
Exterior/inner trim board--Left lower fender of automobile body
Left lower fender of automobile body (LH)
Subassembly
388
Lower fender
Mudguard of
left front wheel
Fixing clasp