Geely CK (2008). Manual part - 53
Geely CK (2008). Manual part - 53
209
5. DOOE COURTESY LAMP SWITCH ( ON DOOR LOCK ACTUATOR)
Inspect door courtesy lamp switch for continuity.
Inspect continuity between the terminal and the ground when the switch operates.
If it is not as specified, replace the switch.
6. REAR TRUNK LAMP SWITCH ASSEMBLY
Inspect rear trunk lamp switch for continuity.
Inspect continuity between the terminal and the ground when the switch operates.
If it is not as specified, replace the switch.
7. ROOM LAMP ASSEMBLY
Inspect each terminal on room lamp assembly for continuity.
If it is not as specified, replace the dome lamp or the switch.
Switch position
Tested terminal
Condition
ON
1 – Ground the body
Continuity
OFF
1 – Ground the body
No continuity
Tested terminal
Condition
ON
1-2
Continuity
OFF
1-2 2-3
No continuity
DOOR (The door is ajar)
2-3
Continuity
DOOR (The door is closed)
2-3
No continuity
ON (Switch is pressed)
1-2
Continuity
OFF 1-2 No continuity
Switch position
Interior dome lamp
LR and RR reading lamps
Switch position
Tested terminal
Condition
ON (The door is well closed)
1 – Ground the body
Continuity
OFF (The door is ajar)
1 – Ground the body
No continuity
1
2
3
210
8. REAR ROW READING LAMP ASSEMBLY
Inspect rear row reading lamp switch assembly continuity
Inspect continuity between the 2 terminals when the switch operates
If it is not as specified, replace the switch.
9. Front fog lamp relay
Inspect front fog lamp relay for continuity
(a) Inspect continuity between terminals
If it is not as specified, replace the relay.
(b) Impose a battery voltage (10V~14V) between terminal 86 and terminal 85, then inspect continuity
between terminal 30 and terminal 87. If not, replace the relay.
Switch position
Tested terminal
Condition
ON
1/2
Continuity
OFF
1/2
No continuity
Tested terminal
Condition
86-85
Continuity
30-87
No continuity
211
Section 3 Headlamp Replacement
I. REMOVAL
1. Remove front bumper (See bumper replacement).
2. Remove the 3 mounting bolts (A, B, C as shown in the illustration) on the headlamp.
3. Remove the electrical connector.
4. Move the assembly forwards and upwards then remove it.
Electrical Connector
212
II.INSTALLATION
1. Install the electrical connector of the headlamp assembly.
2. Install the headlamp assembly and the 3 mounting bolts.
3. Install the front bumper.
4. Adjust the condition of the vehicle.
5. Adjust the headlamp beam.
III.HEADLAMP BULB REPLACEMENT
1 - LOW BEAM DUST COVER 2 - HIGH BEAM DUST COVER 3 - TURN SIGNAL LAMP DUST
COVER 4 - HEADLAMP HOLDER
1. Replace the high and low beam bulbs
y
Turn and remove the dust cover counter-clockwise
y
Pull out the bulb plug
y
Press and release the wire clip
y
Pull out the lamp-holder, and remove the bulb
y
Replace the bulb
2. Replace the turn signal lamp bulbs
y
Remove the 3 screws on the dust cover with screwdriver
y
Turn the lamp-holder counter-clockwise. Pull out the lamp-holder, and remove the bulb
y
Replace the bulb
3. Replace the headlamp bulbs
y
Turn the lamp-holder counter-clockwise. Pull out the lamp-holder, remove the bulb, and replace the
bulb.
1
2
3
4