Ford Aerostar (1997 year). Instruction - page 26

102
Rear seat shoulder safety belt — stowage (with seat
removed)
103
R
WARNING
When reinstalling a rear seat in your
vehicle it must be placed in its original
position. Improper installation of the seat
will prevent correct use of the safety belts
and could increase the risk of injury.
Refer to the warning label on the seat
belt.
2.
Fold the seatback forward and latch it in the
down position (bench seat only).
3.
Rotate the seat latch handles (located under
the seat near the floor) upward, causing the
latch hooks to disengage from the floor
attachment.
4.
Lift seat at rear and rotate about the forward
attachment. When seat latches are clear of
floor attachments, release the latch handles.
5.
Pull the seat rearward to disengage it from
the front floor pins.
Be careful that the latches are not damaged
when the seats are stored.
To install the seat assembly:
1.
Clear the area of debris around the seat floor
attachments.
2.
With the seatback in a folded and latched
position (bench seat only), place the seat
assembly in your vehicle and engage the
front seat hooks onto the forward attachment
pin in the floor wells.
3.
Rotate the seat downward and engage the
latch into the rear floor attachment. Lifting
of the latch handles is not required for
installation.
104
4.
Ensure that the latch handles are fully seated
in the down position.
5.
Before you engage the safety belt, be sure it
is not twisted. A twisted safety belt may
cause the retractor to work improperly.
Remove any twist, then insert the tongue
end of the detachable anchor into the
detachable anchor until you hear a “snap”
and feel the latch engage. Refer to the
previous illustration.
The two passenger bench or bed seat must be
installed in the first row behind the front seats
on wagons with seven passenger seating.
To fold down the rear seatback:
To lower the rear seatback down to its cargo or
bed position, release the seatback latch by
moving the release lever forward for the bench
seat or upward for the seat bed. Then fold the
seatback down. The latch will re-engage in the
cargo position.
To raise the seatback, release the seatback latch
and rotate the seatback upwards until the latch
re-engages. (A slight downward pressure on the
bench seat seatback will reduce effort on the
latch.)
105
Installation and removal of the second and third passenger
bed and bench seat
R
WARNING
Never adjust the driver’s seat or seatback
when the vehicle is moving.
R
WARNING
Always latch the vehicle seat to the floor,
whether the seat is occupied or empty. If
not latched, the seat may cause injury
during a sudden stop.
R
WARNING
Before using the seat, make sure that the
latch hooks are securely locked around the
floor pins.
Рассказать друзьям