Dongfeng EQ1030T47D-820. Instruction - page 40
Cab
BF-15
Cab and Cargo Body
Cab
•The following parts at least should be disassembled in the area of cab engine:
1)Main electric system and wire harness.
•Sparate the engine part from steering transminsion device, brake system and clutch operation system.
•The following parts at least should be disassembled in the area of cab:
1)Transmission system and steering control system.
2)Hand brake operation and brake drag wire.
3)Electric system, wire harness and tube.
Cargo body
•First disassemble the following part:
1)Rear combination light system and license lamp.
Cab
BF-16
Cargo Body Installation
Notes: Different model has different shape of cargo body.
1.
Front board assy
2.
Left side board assy
3.
Right side board assy
4.
Rear board assy
5.
Locking bar assy
6.
Rubber gasket
7.
Rubber base plate
8.
Left rear mudguard
9.
Main sill supporting base plate
10.
Left rear mudguard assy
11.
Buffer stopper
12.
Left locking device assy
13.
Aixs pin
14.
License fixing plate assy
15.Left rear locking bar
16.
Cargo body bottom plate assy
Chassis Frame
BF-17
Chassis Frame
Chassis Frame
1.
Front bumper
2.
Left side member
3.
Front tow hook
4.
1st cross member assy
5.
Left gusset assy
6.
Right side member
7.
Right side member gusset plate assy
8.
Front mounting cross member assy
9.
Body angle iron
10.
Engine rear mounting cross member assy
11.
3rd cross member assy
12.
Cross member
13.
Shock absorber cross member assy
14.
Cross member
15.
Cross member
16.6th cross member
17.
Rear tow hook assy
Heater
BF-18
Heater
Using of Heater
Control panel
Fan switch
There are five speeds provided, from 0 to 4. At 0 position, the fan stops, and the wind will become even
stronger from 1 to 4 speed successively.
Turn these switch to adjust to the satisfied mode if the heater is needed.
Operating-mode chosen switch
—
blowing to your head
—
blowing to your feet
—
blowing both to your head and feet
—
inside heating and defogging
—
inside defogging
Turn the switch to select the needed wind mode.
1.Cab inside air circulating switch
—
circulating internal air
Press this button to circulate the cab inside air and average the air thermal distribution.
Note:
•The warm air is heated by the cooling liquid of the engine. Its temperature depends on the temperature of the
cooling liquid. Please do not use the heating device too long when the engine is stop or idle, otherwise it will wear
out the battery and influence the normal driving.
1.Change-over switch (no use)
2.Fan switch
3.Operating-mode chosen switch
4.Plug
5.Inside air circulation switch
