Dongfeng EQ1030T47D-820. Instruction - page 30
Steering System
ST-3
Steering Wheel and Steering Column
Steering Wheel
·
Remove the horn button.
·
Disassembling the steering wheel by using special tools.
Steering System
ST-4
·
When installing the steering wheel, apply a layer of multi-purposed
grease on the whole surface (two parts) of the automatic return-back pin of
steering indicator and touch point of the horn.
·
Install the steering wheel on the column shaft at the central position.
·
After installing, turn the steering wheel, make sure to have a smooth
movement and the same turning cycles on both left and right side at the
central position.
Steering Column
·
When fixing the steering column, first screw all the lock bolts of lower
bracket and clips with hands, and then re-tightening again to make sure no
extra pressure will apply to the steering column.
·
When fixing the steering spline shaft, make sure that the tightening bolts
and the sunken part of the shaft are correctly faced to each other.
Disassembly and Assembly
·
When assembling and disassembling, turn on the steering lock with the
key.
·
Be sure the surface of the spring lock ring after installing faces with the
shaft.
·
Before putting the shaft into the sleeve, install the spring lock ring.
Steering System
ST-5
·
Install the spring lock ring on the upper shaft with tools.
Steering Lock
a) Remove the lock screw with a clamp.
b) Tightening the lock screw.
Notes:
Pay attention to whether the position of the steering lock mechanism is
correctly located.
Adjusting the Mechanism
·
After installing the steering column, check the movement of the adjusting
mechanism.
Front, Rear
L1: 15mm
L2: 45mm
Upper, Lower
L3: 10mm
L4: 20mm
Check
·
If the steering wheel could not turn smoothly, check the steering column
from the following aspects, and replace relevant damaged parts.
Check whether bearing of the steering column is damaged or uneven,
lubricate it with recommended common grease. If necessary, replace the
steering column assembly.
Check whether the sleeve is deformed or damaged, replace it if necessary.
If the vehicle is hit a little, check the dimension of L. If the L value is ont
in the required range, replace the steering column. L: 484mm
Steering System
ST-6
Steering Gear
1.
Hex neck bolt
2.
Spring washer
3.
Hex nut
4.
Side cover
5.
O rubber sealing ring
6.
Retaining nut
7.
Adjusting bolt
8.
Retaining ring
9.
High pressure sealing ring
10.
Needle bearing
11.
Steering arm shaft
12.
Cone plug
13.
Housing
14.
O rubber sealing ring
15.
Dustproof
16.Spring washer
17.
Hex thin nut
18.
Casing cap
19.
Sealing ring
20.
O rubber sealing ring
21.
Steering nut
22.
Steel ball
23.Steel ball duct
24.
Spring washer
25.
Cross-recessed flat round head screw
26.
Duct clip
27.
Steering screw lever
28.
Cylinder pin
29.O rubber sealing ring
30.
Torsion bar
31.
Valve pocket
32.
Needle bearing
33.
Cylinder pin
34.
Imput shaft
35.
Cylnder pin
36.
Steel ball
37.
Outside ring
38.
Sealing ring
39.
O rubber sealing ring
40.
O rubber sealing ring
41.
Valve body
42.Big cone joint
43.
Circlip for holes
44.
Single annular ball bearing
45.
Oil seal
46.O rubber sealing ring
47.
Upper cover
48.
Retainer nut
49.
Dust cap
