Dongfeng EQ1030T47D-820. Instruction - page 4
General
GL-12
As for the other torques not mentioned, please see the standard of DONGFENG EQB-37-1999.
Note:
No locking spacer, but to make sure the required tightening torque.
When tightening during installing, make use of the oil to lubricate. Do not use the bolt with thread
damaged.
Each bolt need to tighten within 2~3 times.
Muffler fixed bolt
32~38
Battery frame and frame connecting part
35~47
Battery pressure lever fixed nut part
19~24
Front bumper and cross member connecting part
19~24
Power steering oil pipe joint nut
30~40
Air filter bracket and longitudinal connecting part
21~28
Power steering pump adjusting nut
25~31
Power steering pump adjusting bolt
19~25
Alternator adjusting lever bolt and nut
13~19
Push lever bolt of clutch master cylinder
8~11
Clutch pedal brake lock locking nut
12~15
Clutch pressure disc and flywheel fixed bolt
25~35
Fan fixed bolt
7~9
Push lever nut of brake thruster
16~22
Part
Tightening torque (N.m)
Clutch
CL
TOC
Precaution and Preparation
...................................................................... CL-1
Clutch System
............................................................................................. CL-3
Clutch Control System
.............................................................................. CL-4
Clutch Release Mechanism
...................................................................... CL-6
Clutch Driven Disc and Pressure Plate
.................................................. CL-7
Service Data and Specifications
.............................................................. CL-9
Clutch
CL-1
Clutch
Precaution and Preparation
Precaution:
The DOT 4 901-4 compound brake fluid is recommended for the
clutch hydraulic system.
Dirty brake fluid is forbidden to use.
Never let the brake fluid on paint, it may damage the paint coat.
Use tools to assemble or disassemble the clutch pipeline.
Use clean brake fluid to clean the master cylinder, slave clinder and
fluid reservoir.
Forbidden to use mineral oil like gasoline, coal oil ,etc, it will erode
the rubber parts in the hydraulic system.
Note:
After clean the clutch pressure disc, use the dust collector to clean the
dirt, not the compressed air.
Preparation
Specified tools
Clutch
CL-2
Clutch System
1.
Clutch pedal bracket assy
2.Rubber hose assy--oil reservoir to master pump
3.
Clutch master pump assy
4.
Clutch pedal welding assy
5.
Pedal jacket
6.
Clutch pedal shaft
7.
Clutch pedal return spring
8.
Lower fixed board
9.
Dustproof
10.Front oil pipe assy
11.
Spacer
12.Rear oil pipe assy
13.
Clutch rear bent pipe bracket
14.
Hose assy
15.
Gasket
16.
Clutch slave pump assy
