Daewoo Korando. Instruction - page 269

AUTOMATIC TRANSMISSION 5A-119

6. Install the lo-1st spring, ball check valve and roll pin. Refer

to figure 8.49.

7. Install the solenoid 5 damper guide spring, piston and

retaining pin. Refer to figure 8.49.

Figure 8.49 - Solenoid 5 and Damper, Lo-1st Check Valve Assemblies

Figure 8.50 - 1-2 Shift Valve

8. Install the 1-2 shift valve, plug and retaining pin. Refer to

figure 8.50.

5A-120 AUTOMATIC TRANSMISSION

9. Install the 3-4 shift valve and retaining pin. Refer to figure

8.51.

Figure 8.51 - 3-4 Shift Valve

10. Install the 2-3 shift valve and retaining pin. Refer to figure

8.52.

Figure 8.52 - Solenoid 2 and 2-3 Shift Valve

11. Install the 4-3 sequence valve, spring, plug and retaining

plate. Refer to figure 8.53.

Figure 8.53 - 4-3 Sequence Valve

AUTOMATIC TRANSMISSION 5A-121

12. Install the band apply regulator (BAR) valve (refer to figure

8.54), springs, plunger and retainer pin.

Figure 8.54 - Band Apply Regulator Valve and Solenoid 4

13. Install the clutch apply regulator (CAR) valve (refer to figure

8.55), springs, plunger and retainer pin.

Figure 8.55 - Clutch Apply Regulator Valve and solenoid 3

14. Install the solenoid supply valve, spring and retainer plate.

Refer to figure 8.56.

Notice

This aluminum valve is easily damaged.

Figure 8.56 - Solenoid Supply Valve and Solenoid 6

5A-122 AUTOMATIC TRANSMISSION

15. Install solenoid 6 plunger, spring and retaining pin.

16. Position the third feed ball (large nylon) in the valve body

and install the solenoid 5 filter and the solenoid 6 filter.
Refer to figures 8.5 and 8.56.

17. Check the separator plate for burrs and damage. Repair

or replace the separator plate as necessary.

18. Check the upper and lower valve body gaskets for

damage. Replace the gaskets as necessary.

19. Install the lower valve body gasket on the lower valve body.

20. Install the reverse lockout valve, spring, plug and retainer

plate. Ensure that the valve is correctly oriented. Refer to
figure 8.57.

Figure 8.57 - Reverse Lockout Valve

21. Position the five nylon ball checks in the upper valve body.

Refer to figure 8.48.

22. Fit the upper valve body gasket. Install the separator plate

over the upper valve body.