Daewoo Korando. Instruction - page 53
1B2-34 M161 ENGINE MECHANICAL
CYLINDER HEAD COVER
1 Ignition Coil Cover
2 Spark Plug Connector
3 Bolt (M6 X 45 : 4 pieces, M6 X 60 :
6 pieces) ............................................. 10 ± 1 Nm
4 Cylinder Head Cover
5 Gasket ................................................... Replace
M161 ENGINE MECHANICAL 1B2-35
Removal & Installation Procedure
1. Remove the intake air duct.
Installation Notice
2. Remove the ignition coil cover.
Installation Notice
3. Remove the spark plug connector and ignition cable.
Notice
Release 3 screws from the ignition cover and remove the
cover for M161 Engine coil.
Tightening Torque
9 - 11 Nm
Tightening Torque
9 - 10 Nm
1B2-36 M161 ENGINE MECHANICAL
CYLINDER HEAD FRONT COVER
Preceding Work : Removal of cylinder head cover
Removal of thermostat housing assembly
Removal of engine hanger bracket
Removal & Installation Procedure
1. Disconnect the camshaft adjuster connector and remove
the camshaft adjuster (E23 engine only).
Installation Notice
Tightening Torque
9 - 11 Nm
1 Bolt (M6 X 16, 3 pieces) ......................... 9-11 Nm
2 Camshaft Adjuster
3 Bolt (M8 X 35, 2 pieces) ................. 22.5-27.5 Nm
4 Bolt (M6 X 22, 6 pieces) ......................... 9-11 Nm
5 Front Cover (E23 : M161.970)
6 Front Cover (E20 : M161.940)
7 Sleeve
8 O-ring .................................................... Replace
9 Thermostat Housing
M161 ENGINE MECHANICAL 1B2-37
2. Remove the cylinder head front cover.
Installation Notice
Tightening Torque (3)
22.5 - 27.5 Nm
Tightening Torque (4)
9 - 11 Nm
Apply the sealant at the mating surface of the cylinder head
and the front cover.
3. Remove the O-ring.
Installation Notice
Replace the O-ring with new one and apply the sealant.
4. Installation should follow the removal procedure in the
reverse order.