Chrysler 300/300 Touring/300C, Dodge Magnum. Instruction - page 29
8. Install three nuts (2) fastening shock assembly (4)
to shock tower (3). Tighten nuts to 27 N·m (20 ft.
lbs.) torque.
9. If equipped, align shock tower cap (1) with shock
mounting nuts (2) and snap into place.
2 - 70
FRONT
LX
BAR - STABILIZER
REMOVAL
AWD
1. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
2. Remove belly pan. (Refer to 23 - BODY/EXTERIOR/BELLY PAN - REMOVAL)
3. On each side of vehicle, remove nut (5) fastening
stabilizer link (3) to stabilizer bar (4). Slide link ball
joint stem (1) from bar.
4. On each side of vehicle, remove bolts (2) fastening
stabilizer bar isolator retainer (3) in place.
5. Remove stabilizer bar with isolators and retainers
from vehicle.
6. On each side of bar, remove retainers (3) from
around stabilizer bar isolators (1).
7. Utilizing slit, remove each isolator (1) from stabi-
lizer bar (2).
RWD
1. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
2. Remove belly pan. (Refer to 23 - BODY/EXTERIOR/BELLY PAN - REMOVAL)
LX
FRONT
2 - 71
3. On each side of vehicle, remove screws (1) fasten-
ing stabilizer bar heat shield (3). Remove heat
shield.
4. On each side of vehicle, remove bolts (2) fastening
stabilizer bar isolator retainer (1) in place.
5. On each side of vehicle, remove retainer halves
(1)(2) from around stabilizer bar isolator (3).
2 - 72
FRONT
LX
6. Utilizing slit, remove each isolator (1) from stabi-
lizer bar (2).
7. On each side of vehicle, remove nut (5) fastening
stabilizer link (3) to stabilizer bar (4). Slide link ball
joint stem (1) from bar, then remove bar from
vehicle.
INSTALLATION
AWD
1. Utilizing slit in isolator, install each stabilizer bar isolator on bar. Make sure slit in isolator is positioned toward
rear of vehicle once installed on vehicle.
2. Install stabilizer bar isolator retainer over each isolator.
LX
FRONT
2 - 73
