Chrysler 300/300 Touring/300C, Dodge Magnum. Instruction - page 25

16. Install stabilizer bar heat shield (3) over stabilizer

bar bushing retainer. Install mounting screws (1).

17. Install belly pan. (Refer to 23 - BODY/EXTERIOR/

BELLY PAN - REMOVAL)

2 - 54

FRONT

LX

SHOCK ASSEMBLY

REMOVAL

AWD

1. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

2. Remove wheel mounting nuts (3), then tire and

wheel assembly (1).

3. While holding link ball joint stem from rotating,

remove nut (2) fastening stabilizer link (1) to shock
clevis bracket (3). Slide link ball joint stem from cle-
vis bracket.

LX

FRONT

2 - 55

4. Remove nut and pinch bolt (1) fastening clevis

bracket (3) to bottom of shock assembly (2).

5. Remove nut (3) and bolt (1) attaching shock clevis

bracket (2) to lower control arm (7).

6. Pull lower end of clevis bracket outward away from

lower control arm bushing, then slide it off shock
assembly. It may be necessary to use an appropri-
ate prying tool to spread clamp area of clevis
bracket allowing removal from shock assembly.

7. Lower vehicle just enough to access upper shock

assembly mounting nuts (2).

8. If equipped, remove shock tower cap (1) from top

of shock assembly (4).

9. Remove three nuts (2) fastening shock assembly

(4) to shock tower (3).

10. Remove shock assembly from vehicle.

2 - 56

FRONT

LX

RWD

1. If equipped, remove front shock tower cap (1) from

top of shock assembly (4).

2. Remove three nuts (2) fastening shock assembly

(4) to shock tower (3).

3. Raise and support vehicle. (Refer to LUBRICATION

&

MAINTENANCE/HOISTING

-

STANDARD

PROCEDURE)

4. Remove wheel mounting nuts (3), then tire and

wheel assembly (1).

LX

FRONT

2 - 57

Рассказать друзьям