Chrysler 300/300 Touring/300C, Dodge Magnum. Instruction - page 14
5. Remove four bolts (3) fastening hub and bearing
(2) to knuckle.
6. Slide hub and bearing (2) off axle half shaft (1) and
knuckle.
RWD
1. Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)
2. Remove wheel mounting nuts (3), then tire and
wheel assembly (1).
3. Access and remove front brake rotor. (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/ROTOR
-
REMOVAL)
2 - 10
FRONT
LX
4. Remove dust cap (2). When doing this, avoid dam-
aging internal bore of hub to preserve seal integrity.
5. Remove hub nut (1).
6. Slide hub and bearing off knuckle spindle.
INSTALLATION
AWD
NOTE: Before installing hub and bearing on end of
axle half shaft, ensure isolation washer is present
on end of half shaft. Inspect washer making sure it
is not worn or damaged. Washer can be installed
in either direction on shaft.
LX
FRONT
2 - 11
1. Slide hub and bearing (2) onto axle half shaft (1).
Position hub and bearing onto knuckle, lining up
mounting bolt holes.
2. Install four bolts (3) fastening hub and bearing in
place. Tighten mounting bolts to 68 N·m (50 ft. lbs.)
torque.
3. Install brake rotor, then disc brake caliper and
adapter assembly. (Refer to 5 - BRAKES/HYDRAU-
LIC/MECHANICAL/ROTOR - INSTALLATION)
4. Install hub nut (1) on end of axle half shaft (2).
While a helper applies brakes to keep hub from
turning, tighten hub nut to 213 N·m (157 ft. lbs.)
torque.
5. Install tire and wheel assembly (1) (Refer to 22 -
TIRES/WHEELS - INSTALLATION). Tighten wheel
mounting nuts (3) to 150 N·m (110 ft. lbs.) torque.
6. Lower vehicle.
2 - 12
FRONT
LX
7. Pump brake pedal several times to ensure vehicle
has a firm brake pedal before moving vehicle.
8. Check and adjust brake fluid level in reservoir (1)
as necessary.
9. Road test vehicle and make several stops to wear
off any foreign material on brakes and to seat
brake pads.
RWD
NOTE:
Prior
to
installation,
inspect
magnetic
encoder (for wheel speed sensor) (2) for any dam-
age and make sure any metal debris sticking to it
is removed.
1. Slide hub and bearing onto knuckle spindle.
LX
FRONT
2 - 13
