Chery A series. Instruction - page 90
INTERIOR ACCESSORIES(A11 INTERIOR TRIM)
REMOVAL & INSTALLATION OF INSTRUMENT PANEL
REMOVAL:
------Disconnect the negative cable of battery
and pry open the trim panel of steering
wheel. Loosen the locking nut of steering
wheel and take the wheel off.
------Remove the screw under steering column
cover and disconnect the combination
switch wiring harness connector. Take the
switch off.
------Insert a special tool as shown in the right
figure into the four holes of radio to pull
the radio out.
------Disconnect the wiring harness connector
behind the radio.
------Pry out the four light switches from
instrument panel with screwdriver and
disconnect the connectors.
S-11
----Pry out the vents from instrument panel
with screwdriver and remove the six
screws of instrument panel.
----Open up the glove box and remove the
four screws on the top and two sides of
glove box. Pull outward the upper part
of the box to take out the glove box.
-----Pull outward the instrument panel to take
it out.
------Pull out the five connectors of power
window switch and disconnect them.
S-12
------Take the ash tray out and remove the clip
on the top of the ash tray. Remove the
two screws behind central console and
instrument panel.
------Pull out the clip of shift lever dust boot
and central console. Turn in counter
clockwise way the shift lever to remove
it. Remove the screw connecting the
central console and lever bracket.
------Pull upward the back of central console
to disconnect the clip and raise the central
console up from the front to disengage it.
------Take off the A/C panel.
S-13
------Remove the four screws on the two sides
of instrument panel. Remove the two
bolts at where instrument panel and
firewall meet from near wiper motor.
Remove the two bolts connecting the
instrument panel center and the bracket.
------Remove the central electrical box and
pull out the connector connecting the box
and the instrument.
INSTALLATION
------Install in the reverse order of removal.
REMOVAL & INSTALLATION OF FRONT SEAT BELT
REMOVAL
-----Remove the doorsill scuff plate, and
partially remove the weatherproof rubber
strip of the door opening.
-----Remove the cap and loosen the fixing
bolt that secures the seat belt to the
B-pillar.
S-14