Chery A11. Instruction - page 89
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
4. Remove the snap ring and clutch
E assembly;
Use the special tool of
g
7. In
m
5.
KA-001-715-04 bearin
remover to press down piston
E;
6. Take out the retaining ring and
diaphragm spring;
troduce in compressed air fro
the oil feed hole;
103
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
8. Take out piston E;
Replace O-ring on piston E, if
necessary;
1. Put the piston E on the input shaft;
3.
and
9.
Assembly procedure:
2. Press down piston E;
Install the retaining ring
diaphragm spring;
104
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
4. Install clutch E assembly and
snap ring;
the
e clutch E assembly on
utput shaft and 1
st
gear
ne-way overrun clutch
KA
KA
emover
isassem
Remove the automatic
transmission assembly from the
vehicle:
Remove the output shaft and 1
st
gear one-way overrun clutch
from the automatic transmission;
Remove the snap ring on the
output shaft;
Separate the output shaft from the
gear ring;
5. Put the adjusting washer on
input shaft:
6. Install th
the transmission:
7.Install the assembled transmission
assembly on the vehicle.
O
o
Special tool:
KA-000-060 bearing remover
-000-232 bearing remover
-000-300 bearing r
bly procedure:
D
1.
2.
3.
4.
105
CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
5. Remove the tapered roller
bearing from the output shaft
with the special tool of
KA-000-060 (bearing
remover);
Remove the retaining ring and
Remove 1
st
gear one-way
6.
snap ring;
7.
overrun clutch’s inner racer;
106