Chery A11. Instruction - page 58
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install safety ring 17 190 (tooth type of thin steel
ring) and grooved nut 17 200, and tighten
grooved nut with socket spanner 5×46 000 155.
Torque:50Nm
As shown on figure, using appropriate drift, tamp
tooth ring into groove on grooved nut, enhancing
locking.
Turn over housing by 90 ℃ , check clutch
operating condition. Clockwise turn clutch,
confirm clutch can turn smoothly.
Assembling brake D assembly. Install sheet steel
17 050 first, and then install friction plate 17 060,
alternately install, and install retainer ring 17 070,
and then fix with the snap ring 17 080.
-79-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
3.4、Assembling governor driven shaft
Insert piston 33 040 into the governor case 33 030,and
fix with lock sheet 33 050.
-80-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Insert piston 33 070 and spring 33 070, and fix
with lock sheet 33 090.
Governor units are shown on right figure. The
piston may not be divided into three sections.
Install driven shaft into governor for adjusting
governor position much easier. Fix the governor
onto the governor hub 33 010 with four
mounting bolts 33 100.
Tool:27# inner socket spanner
Torque:10Nm
-81-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Fix the centrifugal block 33 098 with bolts.
Install two snap rings 33 020, and let them
interlocked. Install O-ring 33 022 into the
governor hub.
Tool: 27 # inner socket spanner
Torque: 10Nm
Install the governor shroud 33 110.
After applying lubricant Petrolatum or lubricant,
install whole governor into the shroud, and
install governor to seat.
-82-