Chery A11. Instruction - page 39
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.2、 4HP14 A/T power transfer schematic
-3-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
1.3、A/T clearence adjustment
1.3.1 Shift shaft clearence adjustment
Install shift shaft clearence adjuster 5P 95 000
287 on housing surface, ensuring no clearence
between lock cam and shift cam.
Measure the distance X from shift cam to
housing surface with measuring tool.
Determine thickness of washer by following
formula:
S (mm) = X (mm) – 0.1 (mm)
S = washer thickness
X = Measured result
0.10 is selected clearance (selected clearance is within
0.10 ~ 0.2 according to table).
For example
Measured dimensions:
X=2.3mm
S=2.3mm-0.10mm
S=2.2mm
Therefore, need 2 washers with total thickness of 2.2 mm.
-4-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.3.2、Rear output gear clearence
adjustment
1.3.2.1、Main sub output gear clearence
adjustment
Hold driven shaft and output shaft with mounting
bracket 5P 96 000 288 and 5P 95 000 289.
Turn over the transmission body by 180
o
.
stall main rear output gear and mounting bolts.
stall parking mechanism and retain gear shifter
OTE: Keeping brake rotor downward (because
In
Install 1.75 mm thickness washer on driven shaft
and then install sub rear output gear and
mounting bolts.
In
arm on position with adjusting pin 5P 95 000
285.
N
the brake rotor may move outside), then install
parking plunger.
-5-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Tighten sub rear output gear mounting bolt to 10
Nm with torque wrench.
Only after both gears installed correctly can the
parking plunger be removed easily. Turn gear
with an appropriate bolt repeatly (as shown on
fig.).
Install parking plunger, select stop position, then
tighten the bolt. Tighten torque is 20Nm.
Release stop position, turn the gear, and repeat the
above procedures.
-6-