Loader Bobcat 773. Instruction - page 114

B

N–17785

1

1

2

CONTROL HANDLE (ADVANCED HAND CONTROL)
(AHC) (Cont’d)

Control Handle Unit Removal And Installation
(Cont’d)

Using a small screwdrive remove the handle control
electrical connector from the clip [A].

Using an allen wrench, remove the two mounting screws
(Item 1) [B] from the control unit.

NOTE: A small screwdriver (Item 2) [B] in the control

unit may be needed to hold the center spacer
from turning.

Installation: Tighten the control unit mounting screws to
85 in.–lbs. (9,6 Nm) torque.

A

P–13737

–10–20–

Service Manual

773 BICS Loader

Revised June 01

C

N–17470

1

NOTE: The control unit (Item 1) [B] can only be

replaced as a complete assembly.

CONTROL HANDLE (ADVANCED HAND CONTROL)
(AHC) (Cont’d)

Control Handle Unit Removal And Installation
(Cont’d)

Remove the mounting bolt and nut (Item 1) [A] from the
control handle and shaft.

Installation: Tighten the mounting bolt to 35 in.–lbs. (3,9
Nm) torque.

Remove the control unit (Item 2) [A] from the control
handle.

Check the spacer (Item 2) [B] and screws (Item 3) [B] and
replace as needed.

Installation: When installing the control unit into the
steering handle, check the routing of the switch handle
wire harness (Item 1) [C] to assure proper return of the
control handle to neutral.

A

N–17380

1

2

B

N–17392

1

3

2

3

–10–21–

Service Manual

773 BICS Loader

Revised June 01

CONTROL HANDLE (ADVANCED HAND CONTROL)
(AHC) (Cont’d)

Control Unit Connector

The wire connector (Item 1) [A] can be removed from the
handle control unit wires, use the following procedure.

Remove the wedge (Item 1) [B] from the connector.

With a pointed tool, lift the tab (Item 1) [C] and pull the wire
from the connector.

Assembly: Install the wires into the connector as listed
below [C]:

1–Terminal – Red

2–Terminal – Black

3–Terminal – Green

C

P–17333

1

3

1

2

A

N–17392

1

B

P–13732

P–13725

1

1

–10–22–

Service Manual

773 BICS Loader

Revised June 01

A

N–17786

1

CONTROL HANDLE (ADVANCED HAND CONTROL)
(AHC) (Cont’d)

Switch Handle Removal And Installation

Remove the handle control unit from the steering lever.
(See Page 10–19.)

To remove the switch handle the connector (Item 1) [A]
must be removed from the wires, use the following
procedure:

Remove the wedge (Item 1) [B] from the connector.

Using a pointed tool, press down on the tab (Item 1) [C]
and pull the wire from the connector.

Installation: Install the wires into the connector as listed
below [C]:

Right Steering Lever Switch Handle

1–Terminal – Pink/Red
2–Terminal – Pink/Black
3–Terminal – Pink/Green

Left Steering Lever Switch Handle

1–Terminal – Brown/Red
2–Terminal – Brown/Black
3–Terminal – Brown/Green

B

P–13732

P–13725

1

1

–10–23–

Service Manual

773 BICS Loader

Revised Nov. 01

C

P–17335

1

3

2

1

Рассказать друзьям